The Cooling After unit plugs into the WOL (Wake On Lan) header on your motherboard.. It draws power from the header to power up two 12V connectors. Each connector can be used to daisy chain up to three devices each to a maximum power draw of 12 watts.

The CA also has a pass-thru connector in case you need the WOL header for your NIC. , so you can connect the CA to your WOL header, than connect your NIC to the CA.

With the LED connector on the CA you can monitor it's status. You can connect it to either one the LEDs on your case or to your custom installed LEDs.

LED Indicator:

• On: System is on and fans are running at normal speed.
• Blinking: System is off, timer is activated and fans are running slowly.
• Off: System is off and fans are stopped.

The package includes:

• (1) Controller
• (1) WOL link cable
• (2) 3 pin Fan to 3 pin Fan cable
• (1) LED 3 pin to 2 pin adapter cable
• (1) Molex Male to Fan 3 pin cable
• (1) Molex Female to Fan 3 pin cable
• (1) Velcro (Magic Tape) for mounting

It's easy to mount. Just use the velcro tape (included) or attach it with screws using the holes for the slot bays on the rear of the case.