|
Above you see that nice large 92mm exhaust fan from the included Smartblue power supply. On the far right you see where the one front instake fan (optional) goes (see below pic for a better look) , it's that mean green enclosure so no screws are necessary. Also notice above-left where an additional rear exhaust fan (optional) can go. Screws are needed for that fan.
In the very top picture you see where air can get in for any front intake fan you add, but also notice the above-right close-up pic of the front grill. No air restriction with this puppy. In the above-left pic you see the drive cage. Unlike other Antec cases this one holds the floppy and the hard drive(s). But it doesn't have a drive cage fan as the other Antec cases have either. Everything so far has added up to decent cooling but that omission. Though it had to be because of the contruction in trying to fit in the floppy drive.
Above is of course the rear of the case. Again notice where a rear exhaust case fan would go. Not only big air holes but the cage extends out slightly to further add to allowing more free air flow. When you go to a Lan you may need to protect your valuable peripherals from others. Notice in the rear it has a place where you can use a lock to help secure your case. Now what the heck is that funny looking thang near the bottom?
Sometimes at a Lan get together you need some screws and assorted hardware. Antec has made a cool and useful adition with that lil pocket. They even included a small package full of assorted screws.
Next Page >
< Previous Page >
