|
I assembled a system using the following components.
- Epox 4SDA5+ Motherboard
- Intel Celeron 2.0Ghz Processor
- ThermalTake 478 Volcano CPU HSF
- 2(x)256mb PC2100 DDR RAM
- GF4 MX420 64mb
- Maxtor 20GB 5400 RPM Hard Drive
- Pioneer 24X Slot Load CD-ROm Drive
Nothing special but it should give you a good idea of what you'll run accross when you build one in this case.
I also included the cold cathode light kit and 80mm LED fan supplied by MaxTop as well as an 80mm Antec fan that I had laying around. I like to have a fan at both the front and back of the case to help insure good air flow.
The case material is a little thinner metal than I'm accustomed to. That was apparent when I laid the motherboard tray on my lap to check for positioning the standoffs. The panel can be removed after removing the side panel on the mobo side of the case and unscrewing the last remaining achor screw. The tray come with six brass standoffs screwed into it and you'll find plenty of "snap-in" standoffs to finish the installation. Also notice that edge of the mobo tray is not rolled at the corners and it is a bit rough on the edges. You might want to watch that when taking apart and assembling the case.
The motherboard tray easily accepts a standard ATX motherboard.
Next Page--->
